USB cable
USB cable
release lever
There are release levers on the Ethernet and systems management connectors. To
disconnect a cable from one of these connectors, pull up on the lever to release the
cable.
Ethernet speed LED
Ethernet activity LED
Ethernet port
Ethernet cable
release lever
Updating the server configuration
When you start the server for the first time after you add or remove an internal
option or external device, you might receive a message that the configuration has
changed. The Configuration/Setup Utility program starts automatically so that you
can save the new configuration settings.
Some options have device drivers that you must install. For information about
installing device drivers, see the documentation that comes with each option.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
If you have installed a Remote Supervisor Adapter ll SlimLine to manage the server
remotely, see the Remote Supervisor Adapter ll SlimLine User’s Guide, which
comes with the adapter, for information about setting up, configuring, and using the
adapter.
For information about configuring the integrated Gigabit Ethernet controllers, see
the User’s Guide.
28 IBM System x3550 Type 7978: Installation Guide
To Next Page
Loading...
Need help?
General