Removing a riser card assembly
To remove a riser assembly, complete the following steps.
Riser-card
assembly
Expansion
slot 1
Riser card
connector
PCI Express Adapter
Expansion
slot cover
Adapter
support
bracket
Riser-card
assembly
Adapter
support
bracket
Expansion slot 2
Expansion
slot cover
Riser-card
connector
PCI adapter
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the cover (see “Removing the cover” on page 42).
3. If an adapter is installed in the riser card assembly, disconnect any cables
connected to the adapter.
4. Grasp the riser-card assembly at the rear edge and lift to remove the riser-card
assembly.
5. Remove the adapter, if one is present, from the riser card assembly.
6. If you are instructed to return the riser card assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 4. Removing and replacing server components 75
To Next Page
Loading...
Need help?
General