To Next PageTo Next Page
Why no sound is coming from the Icom COMMUNICATIONS IC-R3 Receiver speaker?
If no sound is coming from the Icom Receiver's speaker, there might be a few reasons: * The volume could be set too low. Try increasing it by pushing the [UP] button. * The squelch level might be set too tight. Try opening the squelch. * If you're using tone squelch, a different tone might be selected. Use the tone scan to check the tone.
How to fix Icom COMMUNICATIONS IC-R3 when no power comes on?
If your Icom Receiver isn't powering on, the issue is likely related to the batteries. Either the batteries are exhausted, in which case you should replace them or charge the battery pack. Or the battery polarity is reversed, so you should check the battery polarity.
What to do if frequency cannot be set on Icom COMMUNICATIONS IC-R3 Receiver?
If you're unable to set the frequency on your Icom Receiver, it's possible that the lock function is activated. To deactivate it, push [FUNC] + [MODE(SET)] for 2 seconds.
Why is the receive audio distorted on my Icom Receiver?
If the audio you're receiving on your Icom Receiver is distorted, the operating mode might not be selected correctly. Try pushing the [MODE] button to select a more suitable operating mode.
General
