17
5
MEMORY CHANNELS
■ Memory names
Each memory channel and scan edge channels can be pro-
grammed with an alphanumeric name such as a repeater
name, club name, etc., for easy recognition. Names can be a
maximum of 6 characters—see the table at right for available
characters.
The color LCD and memory names can be used when the
operating frequency is 30 MHz and above.
q Push [FUNC] + [↕] for 2 sec. to turn the color LCD ON.
w Push [FUNC] + [↕] one or more times to select the simple
or multi-function screen.
•The memory names are available for the simple and multi-func-
tion screens only.
e Select the desired memory channel.
r Push [FUNC] + [(V/M)SKIP] for 2 sec. to program the
memory name.
•The first character of the name flashes.
t Rotate the tuning dial to select the desired character.
•See the following table for a list of available characters.
y Push [↔] (right) to advance to the next character.
•Push [↔] (left) to select the previous character.
u Repeat t and y until the desired name is input.
i Push [V/M] to program the name and exit programming
mode.
o If you want to set other channels, rotate the tuning dial. Re-
peat r through i to set the desired name.
The memory names are automatically programmed into
the memory channels.
To Next Page
Loading...
Need help?
General
