5
3
BASIC OPERATION
■ Receiving and transmitting
CAUTION: Transmitting without an antenna may dam-
age the transceiver.
q Rotate [VOL] clockwise to turn power ON, then set to the
10 o’clock position.
w Push [V/M] to select memory mode or VFO mode.
e Select the desired memory channel or VFO frequency with
the [Y]/[Z] keys.
•When receiving a signal, “BUSY” appears and audio is emitted
from the speaker.
• Further adjustment of [VOL] may be necessary at this point.
• Push [SQL] to toggle the squelch function ON and OFF. (p. 6)
•When the dial select function is selected, each push incre-
ments/decrements the frequency either 100 kHz or 1 MHz. (p. 7)
r Push and hold [PTT] to transmit, then speak into the mi-
crophone.
• Transmit indicator lights.
t Release [PTT] to receive.
ï Memory ➾ VFO
Memory channel contents can be moved to VFO .
q Select memory channel to be transferred:
➥ Push [V/M] to select memory mode, if necessary.
➥ Push [Y] or [Z] to select the memory channel.
w Push [V/M] key for 2 sec. to transfer the memory contents
to VFO.
- VFO mode is selected
NOTE:
• Only frequency data is transferred even if the memory
channel has a memory name.
•When the preprogrammed memory frequency is outside
the range of the preprogrammed VFO edges, an error
beep tone sounds and no data is transferred.
To Next Page
Loading...
Need help?
General
