Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries.
SERVICE CAUTION
NEVER connect the transceiver to an AC outlet or
to a DC power supply that outputs more than the
specified voltage. This will ruin the transceiver.
DO NOT reverse the polarity of the DC power cable
when directly connecting to the transceiver.
DO NOT apply an RF signal of more than 20 dBm
(100 mW) to the antenna connector. This could
damage the transceiver’s front-end.
ORDERING PARTS
Be sure to include the following four points when
ordering replacement parts:
1. 10-digit Icom part or order number
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
8610014711 KNOB N-421-1 IC-F2000 CHASSIS 5 pieces
03 41121103
U F2000 #11 CHASSIS
IC-F2000 CHASSIS 1 piece
REPAIR NOTES
1. Make sure that the problem is internal before
disassembling the transceiver.
2. DO NOT open the transceiver until it is
disconnected from its power source.
3. DO NOT short any circuits or electronic parts.
DO NOT keep power ON for a long time when the
transceiver is defective.
4. NEVER directly transmit power into any test
equipment such as Standard Signal Generator,
otherwise the RF power may damage them.
5. ALWAYS connect a 30 dB to 40 dB attenuator
between the transceiver and such test equipment.
6. READ the instructions of the test equipment
thoroughly before connecting it to the transceiver.
7. If the front panel and chassis are separated and
reassembled, waterproof performance will not be
guaranteed unless the specified waterproof check
is performed.
IC-F2000 IC-F2000S IC-F2000T
To Next Page
Loading...
Need help?
General
