1-2
■
TRANSMITTER
• Output power: 4 W
• Modulation: Variable reactance frequency modulation
• Maximum permissible deviation:
Wide ±5.0 kHz
Middle ±4.0 kHz
Narrow ±2.5 kHz
• Frequency stability: ±2.5 ppm
• Spurious emissions: 0.25 μW (≤1 GHz) (EN 300 086, EN 300 296, AZ/NZS 4295)
1.0 μW (>1 GHz) (EN 300 086, EN 300 296, AZ/NZS 4295)
70 dB minimum (TIA-603, RSS-119)
• Adjacent channel selectivity:
Wide, Middle 70 dB minimum, 74 dB typical
Narrow 60 dB minimum, 69 dB typical
• Audio harmonic distortion:
Wide, Middle 1.0% typical at AF 1 kHz 40% deviation
Narrow 1.5% typical at AF 1 kHz 40% deviation
• FM hum and Noise:
With CCITT Filter Wide 45 dB minimum, 53 dB typical
(EN 300 086, EN 300 296)
Middle 43 dB minimum, 51 dB typical
(EN 300 086, EN 300 296)
Narrow 40 dB minimum, 48 dB typical
(EN 300 086, EN 300 296)
Without CCITT Filter Wide 40 dB minimum, 46 dB typical
(AZ/NZS 4295)
Narrow 34 dB minimum, 40 dB typical
(TIA-603, RSS-119, AZ/NZS 4295)
• Input impedance (Microphone): 2.2 kΩ
■
RECEIVER
• Intermediate frequencies: 1st 46.35 MHz
2nd 450 kHz
• Sensitivity:
−4 dBμV emf typical at 20 dB SINAD (EN 300 086)
0.25 μV
* typical at 12 dB SINAD (TIA-603, RSS-119, AS/NZS 4295)
• Squelch sensitivity (threshold):
−8 dBμV emf typical (EN 300 086)
0.25 μV
* typical (TIA-603, RSS-119, AS/NZS 4295)
• Adjacent channel selectivity:
Wide 70 dB minimum, 75 dB typical
Middle 70 dB minimum, 73 dB typical
Narrow 60 dB minimum, 67 dB typical
• Spurious response: 70 dB minimum
• Intermodulation: 65 dB minimum (EN 300 086)
70 dB minimum, 73 dB typical (TIA-603, RSS-119, AS/NZS 4295)
• Hum and Noise:
With CCITT Filte Wide 45 dB minimum, 52 dB typical (EN 300 086)
Middle 43 dB minimum, 50 dB typical (EN 300 086)
Narrow 40 dB minimum, 47 dB typical (EN 300 086)
Without CCITT Filter Wide 40 dB minimum, 46 dB typical (AS/NZS 4295)
Narrow 34 dB minimum, 40 dB typical (TIA-603, RSS-119, AS/NZS 4295)
• Audio output power: Internal speaker 1.5 W typical (at 5% distortion into the 8 Ω load)
External speaker 0.4 W typical (at 5% distortion into an 8 Ω load)
• Output impedance (Speaker): 8 Ω
*
The input signal strength level of this receive sensitivity is measured at the load end (PD).
All stated specifications are subject to change without notice or obligation.
To Next Page
Loading...
Need help?
General
