Icom IC-F521 Instruction Manual

20
3
BIIS OPERATION
New2001
■ Position data transmission
When the optional OPC-822 INTERFACE CABLE and a GPS re-
ceiver is connected to the transceiver, the position (longitude
and latitude) data can be transmitted automatically.
Ask your dealer or system operator for connection details.
The position data is transmitted when;
• Status 24 message is received
*When the status 24 message, GPS request, is received.
• Fully automatic
When automatic position transmission is enabled, send
the position data according to ‘Time Marker’ and ‘Inter-
val’ settings.
• PTT is released
When ‘Send At Log-off’ is enabled.
• After sending a status message
When ‘Send With Status’ is enabled.
• After sending an SDM
When ‘Send With SDM’ is enabled.
• After sending status 22 (Emergency)
When ‘Send With Emergency’ is enabled.
■ Printer connection
When the optional OPC-822 INTERFACE CABLE is connected
to the transceiver, a printer can be connected to printed out
the received SDM content and the ID of the station who sent
the message. Ask your dealer or system operator for connec-
tion details.
■ PC connection
When the optional OPC-822 INTERFACE CABLE
is connected
to the transceiver, a PC can be connected to provide remote
control, data reception, etc.
Ask your dealer or system operator for connection details.
■ Digital ANI
The own ID can be transmitted each time the PTT is pushed
(log-in) or released (log-off) during individual or group call
communications.
By receiving the ANI, the communication log can be recorded
when using a PC dispatch application.
In addition, when using the ANI with log-in, the PTT side tone
function can be used to inform you that the ID is sent and
voice communication can be performed.
IC-F510 Series_BIIS-2.qxd 06.7.13 1:31 PM Page 20 (1,1)

Icom IC-F521 Specifications

General

Brand	Icom
Model	IC-F521
Category	Transceiver
Language	English