22
3
BIIS OPERATION
New2001
■ Priority A channel selection
When one of the following operations is performed, the trans-
ceiver selects the Priority A channel automatically.
Priority A is selected when;
• Clear down signal is received/transmitted
- Set the “Move to PrioA CH” item as “Clear Down.”
• Turning the power ON
The Priority A channel is selected each time the trans-
ceiver power is turned ON.
• Status call
The Priority A channel is selected when transmitting a sta-
tus call.
- Enable the “Send Status on PrioA CH” item in the MSK
configuration.
IC-F510 Series_BIIS-2.qxd 06.7.13 1:31 PM Page 22 (1,1)
To Next Page
Loading...
Need help?
General
