Icom IC-F521 Service Manual

S
SECTION 1 SPECIFICATIONS
1 - 1
USA/GEN EUR
GENERAL
Measurement method EIA-152-C/204D or TIA-603 ETS 300 086
Frequency coverage 136.000–174.000 MHz
Type of emission
[N/W]: 8K50F3E/16K0F3E (15 kHz; Narrow/30 kHz; Wide) [USA]
[N/W]: 8K50F3E/16K0F3E (12.5 kHz; Narrow/25 kHz; Wide) [GEN], [EUR]
[N/M]: 8K50F3E/14K0F3E (12.5 kHz; Narrow/20 kHz; Middle) [EUR]
Number of conventional channels Max. 256 ch (16 channels
×
16 banks)
Power supply voltage (negative ground) 13.6 V DC nominal 13.2 V DC nominal
Current drain (approx.)
Frequency error 5.0 ppm
±
1.5 kHz
Usable temperature range –30ºC to +60ºC (–22ºF to +140ºF) –25ºC to +55ºC
Dimensions (proj. not included) 140(W)
×
40(H)
×
170(D) mm; 5
1
⁄
2
(W)
×
1
9
⁄
16
(H)
×
6
11
⁄
16
(D)
Weight 1.2 kg; 2 lb 10 oz
TRANSMITTER
RF output power High/Low2/Low1: 25 W/10 W/2.5 W [25W], 50 W/25 W/5 W [50W]
Modulation system Variable reactance frequency modulation
Maximum permissible deviation
±
2.5 kHz [Narrow],
±
4.0 kHz [Middle],
±
5.0 kHz [Wide]
Spurious emissions 70 dB typical 0.25 µW
≤
1 GHz, 1.0 µW
>
1 GHz
Adjacent channel power 60 dB [Narrow], 70 dB [Middle]/[Wide]
Audio frequency response
+2 dB to –5 dB of 6 dB/octarve
range from 300 Hz to 2550 Hz [Narrow]/3000 Hz [Middle]/[Wide]
Audio harmonic distortion 3% typical at 1 kHz, 40% deviation
FM hum and noise (typical)
(without CCITT fi lter)
40 dB [Narrow], 46 dB [Wide] –––
Residual modulation (typical)
(with CCITT fi lter)
––– 50 dB [Narrow], 53 dB [Middle], 55 dB [Wide]
Limiting charact of modulator 70–100% of max. deviation
Microphone connector 8-pin modular (600
Ω
)
RECEIVER
Receive system Double-conversion superheterodyne system
Intermediate frequencies 1st: 46.35 MHz, 2nd: 450 kHz
Sensitivity (typical) 0.25 µV at 12 dB SINAD –4 dBµV (emf) at 20 dB SINAD
Squelch sensitivity (typical) 0.25 µV –4 dBµV (emf)
Adjacent channel selectivity (typical) 65 dB [Narrow], 75 dB [Middle/Wide]
Spurious response 75 dB
Intermodulation (typical) 74 dB 67 dB
Hum and noise
(typical)
(without CCITT fi lter) 40 dB [Narrow], 45 dB [Wide] –––
(with CCITT fi lter) ––– 50 dB [Narrow], 53 dB [Middle], 55 dB [Wide]
Audio output power 4 W typical at 10% distortion with a 4
Ω
load
External SP connector 2-conductor 3.5 (d) mm (
1
/
8
")/4
Ω
All stated specifi cations are subject to change without notice or obligation.
RECEIVING TRANSMITTING
Stand-by Max. audio 50 W 25 W
300 mA 1200 mA 14.0 A 7.0 A

Icom IC-F521 Specifications

General

Brand	Icom
Model	IC-F521
Category	Transceiver
Language	English