clear after entering 6 digits, the input code
number may be wrong. In that case, turn the
power OFF, and start over.
NOTE: A default passcode is “159357”;
Push [P1], [P0], [P4], [P3], [P0], [P2] in sequence.
er
passcode, push [P3].
• “CLONE” is displayed.
6Push [CH Up] or [CH Down], or rotate [CH
Up/Down] to select “TACTICAL.”
7Push [ ] to copy zone 128 data of the master
transceiver, to zone 128 of the sub transceiver.
Handheld to Mobile connection
NOTE: If [ ] is pushed when “CLONE” is
displayed, the regular cloning operation is
performed (all data, including zone 128, of the
master transceiver is written to the sub
transceiver).
For actual appearance of the cables, please
refer to 3-5 Optional Accessories.
Cloning the tactical group
<Master (Zone 128) ➔ Sub (Zone 128)>
(Continued)
2Turn the sub transceiver power ON.
3Set the master transceiver into the set mode as
follows;
While pushing [P0] and [P4] on the master
transceiver, push [ ] to turn the power ON.
• “DEALER” is displayed.
4Input the 6 digit dealer passcode, as specified by
your dealer.
• The 10-keypad* can be used for pass code
in
* 10-key models only
• When using a Simple model transceiver, the
keys in the table shown below can be used for
pass code input.
• The transceiver detects numbers in the same
block as identical. Therefore 0 and 5, 1 and 6,
etc. are the same.
58
To Next Page
Loading...
Need help?
General
