Icom IC-FR3000 Service Manual

4 - 7
4-4 SOFTWARE ADJUSTMENT
Select an operation using [CH-UP] / [CH-DN] keys, then set specified value using [RPT/BASE] / [MONI] keys on the FRONT
PANEL.
1
2
1
2
1
2
• LCD display : A06 HW POWER
• Operating freq. : 162.2750 MHz
• Connect an RF power meter to the [TX]
antenna connector.
• Transmitting
• LCD display : A06 LW POWER
• Operating freq. : 162.2750 MHz
• Transmitting
• LCD display : A07 LW M DEV
• Operating freq. : 162.2750 MHz
• IF bandwidth : Wide
• Connect an audio generator to the [MIC]
jack through the JIG cable and set as:
1.0 kHz/40 mVrms
• Set an FM deviation meter as:
HPF : OFF
LPF : 20 kHz
De-emphasis: OFF
Detector : (P–P)/2
• Transmitting
• LCD display : A08 LW LMODC
• Operating freq. : 150.2750 MHz
• IF bandwidth : Wide
• Connect an audio generator to the [MIC]
jack through the JIG cable and set as:
1.0 kHz/40 mVrms
• Set an FM deviation meter as:
HPF : OFF
LPF : 20 kHz
De-emphasis: OFF
Detector : (P–P)/2
• Transmitting
• LCD display : A09 LW HMODC
• Operating freq. : 173.725 MHz
• Transmitting
• LCD display : A10 LW CTCDEV
• Operating freq. : 162.2750 MHz
• Set the FM deviation meter as:
HPF : OFF
LPF : 20 kHz
De-emphasis: OFF
Detector : (P–P)/2
• No audio applied to the [MIC] connector.
• Transmitting
• LCD display : A12 LN CTCDEV
• Operating freq : 162.2750 MHz
• No audio applied to the [MIC] connector.
• Transmitting
Rear
panel
Rear
panel
Rear
panel
Rear
panel
Connect an RF power meter to
the [TX] antenna connector.
Connect an FM deviation meter
to the [TX] antenna connector
through the attenuator.
Connect an FM deviation meter
to the [TX] antenna connector
through the attenuator.
Connect an FM deviation meter
to the [TX] antenna connector
through the attenuator.
50.0 W
[USA2], [GEN2], [GEN4]
25.0 W
[EUR2], [FRG2]
10.0 W
[USA2], [GEN2], [GEN4]
5.0 W
[EUR2], [FRG2]
±4.4 kHz [Other]
±3.5 kHz [FRG2]
±4.4 kHz [Other]
±3.5 kHz
[FRG2]
±4.4 kHz [Other]
±3.5 kHz
[FRG2]
±0.65 kHz [Other]
±0.52 kHz [FRG2]
±0.35 kHz
ADJUSTMENT ADJUSTMENT CONDITION
MEASUREMENT
VALUE
UNIT LOCATION
*The output level of the standard signal generator (SSG) is indicated as the SSG’s open circuit.
OUTPUT
POWER
Power (Hi)
Power (LOW)
DEVIATION
MODULATION
BALANCE
(LOW FRQ.)
(HIGH FRQ.)
CTCSS
DEVIATION
[WIDE]
[NARROW]

Icom IC-FR3000 Specifications

General

Brand	Icom
Model	IC-FR3000
Category	Repeater
Language	English