19
7
SET MODE
New2001
7
D Scan resume timer “St”
The scan resume timer can be set as a pause (OFF) or timer
scan (ON). When OFF is selected, the scan pauses until a
received signal disappears. When ON is selected, the scan
pauses for 5 sec. after receiving a signal and then resumes
even if the signal has been received.
D Auto scan function “AS”
The Auto scan function starts the desired scan automatically
when no signal is received, and no operation is performed
for 30 sec.
D Dual/Tri-watch function “dt”
This item selects dual or tri-watch as desired. See p. 16 for
details.
D Monitor switch action “Sq”
The monitor switch action cuts off the squelch function tem-
porarily. This switch action contains PUSH (Pu) or HOLD
(Ho) settings as shown below.
• Pu (PUSH): After pushing the [SQL•MONI] for 1 sec., the squelch
opens and emits audio. The squelch is held open
while continuously pushing and holding [SQL•MONI].
(default)
• Ho (HOLD): After pushing the [SQL•MONI] for 1 sec., the squelch
opens and emits audio even [SQL•MONI] is released.
To close the squelch, push any key.
Push
Scan resume timer OFF
(default)
Scan resume timer ON
Push
Push setting (default) Hold setting
Push
Auto scan OFF (default) Auto scan ON
Push
Dualwatch function
(default)
Tri-watch function
To Next Page
Loading...
Need help?
General
