Icom IC-M59 User Manual

Beep tones (p. 20)
Normal/priority
scan (p. 20)
Weather alert (p. 20)
Scan timer (p. 20)
Address ID (p. 21)
Scramble code (p. 20)
Each push of [16] selects a SET mode item in order.
Acknowledgement
method
(p. 21)
Auto acknowledge
contents (p. 21)
When UX-120 is installed.
When UT-79 is installed.
SET MODE
5
19
■ Entering SET mode
SET mode is used to customize operation of the transceiver
to suit your operating needs.
D To enter SET mode:
➀ While pushing [16], turn power ON.
• Keep pushing [16] until the initial SET mode display appears.
• SET mode is selected.
➁ To exit SET mode, turn power OFF then ON again.
D To select an item:
There are up to 8 items in SET mode (depending on options
installed) that may be adjusted to suit your operating needs.
➀ Select SET mode as above.
➁ Push [16] to select the desired item; then rotate [CHAN-
NEL] to select the desired condition.
• See the following pages for details on each SET mode item.
The diagram at right shows
the default settings for each
SET mode item and the
order of selection.
Items inside dotted lines only
appear when optional units
are installed.
■ SET mode items

Icom IC-M59 Specifications

General

Brand	Icom
Model	IC-M59
Category	Transceiver
Language	English