ii
UNPACKING
Accessories included with the transceiver: Qty.
q Antenna............................................................................1
w Handstrap ........................................................................1
e Battery pack (BP-173/BP-180) or battery case (BP-170)
attached to the transceiver ..............................................1
r Belt clip ............................................................................1
t Wall charger*....................................................................1
*Not supplied with battery case versions.
Antenna for U.S.A. version differs from that shown above.
DO NOT push the PTT when not actually desiring to
transmit.
DO NOT operate the transceiver near unshielded electri-
cal blasting caps or in an explosive atmosphere.
AVOID using or placing the transceiver in direct sunlight or
in areas with temperatures below –10°C (+14°F) or above
+60°C (+140°F).
Place unit in a secure place to avoid inadvertent use by chil-
dren.
The use of non-Icom battery packs/chargers may impair
transceiver performance and invalidate the warranty.
Even when the transceiver power is OFF, a slight current still
flows in the circuits. Remove the battery pack or case from
the transceiver when not using it for a long time. Otherwise,
the battery pack or installed dry cell batteries will become
exhausted.
For U.S.A. only
CAUTION: Changes or modifications to this device, not
expressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.
IC-T7H-2.qxd 2007.07.19 4:10 PM Page ii
To Next Page
Loading...
Need help?
General
