Step 3 Remove and clean the metal
frame and the seal.
Step 4 Replace the lamp with a suita‐
ble 300 °C heat-resistant lamp.
Step 5 Install the metal frame and the
seal. Tighten the screws.
Step 6 Install the left shelf support.
Troubleshooting
Warning! Refer to Safety
chapters.
What to do if...
The appliance does not turn on or does not heat up
Possible cause
Remedy
The appliance is not connected to an electri‐
cal supply or it is connected incorrectly.
Check if the appliance is correctly connected
to the electrical supply.
The clock is not set. Set the clock, for details refer to Clock func‐
tions chapter, How to set: Clock functions.
The door is not closed correctly. Fully close the door.
The fuse is blown. Make sure the fuse is the cause of the prob‐
lem. If the problem recurs, contact a quali‐
ed electrician.
The appliance Child Lock is on. Refer to "Menu" chapter, Submenu for: Op‐
tions.
Components
Description
Remedy
The lamp is burnt out. Replace the lamp, for details refer to "Care
and Cleaning" chapter, How to replace:
Lamp.
Power cut always stops cleaning. Repeat
cleaning if it's interrupted by power failure.
How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will nd the list of the problems that you can handle on your own.
ENGLISH 33
To Next Page
Loading...
Need help?
General