EN
EN-4 22204911 Rev. E
This manual provides safe and reliable instructions for the installation, operation and maintenance of your Ingersoll Rand air
compressor. Carefully read this manual before attempting to operate or perform any maintenance. If you are uncertain about
any of the instructions or procedures provided in this manual, contact Ingersoll Rand. We recommend you retain this manual,
and all publications provided with your air compressor, in a location which is accessible to all personnel who operate and
service your compressed air equipment.
ABOUT THIS MANUAL
SAFETY INFORMATION
EXPLANATION OF SAFETY SIGNAL WORDS
Throughout this manual there are steps and procedures
which, if not followed, may result in a hazard. The following
signal words are used to identify the level of potential hazard.
DANGER
Indicates an imminently
hazardous situation which, if not
avoided, will resulting death or
serious injury.
WARNING
Indicates a potentially hazardous
situation which, if not avoided,
could result in death or serious
injury.
CAUTION
Indicates a potentially hazardous
situation which, if not avoided,
may result in minor or moderate
injury or property damage.
NOTICE
Indicates information or a
company policy that relates
directly or indirectly to the safety
of personnel or protection of
property.
GENERAL SAFETY PRECAUTIONS
INTAKE AIR
Can contain carbon monoxide or other contaminants.
Will cause serious injury or death. Ingersoll Rand air
compressors are not designed, intended or approved
for breathing air. Compressed air should not be used for
breathing air applications unless treated in accordance
with all applicable codes and regulations.
WARNING
HAZARDOUS VOLTAGE
Can cause serious injury or death. Disconnect power
and bleed pressure from the tank before servicing.
Lockout/Tagout machine. Compressor must be
connected to properly grounded circuit. See grounding
instructions in manual. Do not operate compressor in
wet conditions. Store indoors.
WARNING
MOVING PARTS
Can cause serious injury. Do not operate with guards
removed. Machine may start automatically. Disconnect
power before servicing. Lockout/Tagout machine.
WARNING
HOT SURFACES.
Can cause serious injury. Do not touch. Allow to cool
before servicing. Do not touch hot compressor or
tubing.
WARNING
HIGH PRESSURE AIR.
Bypassing, modifying or removing safety/relief valves
can cause serious injury or death. Do not bypass,
modify or remove safety/relief valves. Do not direct air
stream at body. Rusted tanks can cause explosion and
severe injury or death. Drain tank daily or after each
use. Drain valve located at bottom of tank.
CA
RISK OF BURSTING
Use only suitable air handling parts acceptable for
pressure of not less than the maximum allowable
working pressure of the machine
RELEASED 13/Feb/2019 14:38:46 GMT
To Next Page
Loading...
Need help?
General
