112
www.insigniaproducts.com
Appendix NS-32E859A11/NS-42E859A11
3 Press the mode button that you want to remove the
learned button from, then press the button containing the
learned function to be deleted, twice. The LED blinks twice
and programming ends.
Deleting all learned buttons in a specific
mode
To delete all learned buttons in a specific mode:
1 Press and hold the A and D buttons at the same time until
the LED blinks twice, then release.
2 Enter 9 7 6. The LED blinks twice.
3 Press the mode button twice (for example, DVD, STB, or
AUX) to clear all the learned buttons for that mode. The
LED blinks twice and programming ends.
Programming macros
Your can program any button (except the TiVo button) on your
remote control with a macro function. Each button can be set
up to perform a pre-programmed set of sequential button
presses with the press of a single button. You can use a macro
to control a home theater operation, to set a favorite channel,
or for other functions you want to control with one button
press. Each macro button can hold up to 32 button presses.
You can program two types of macros:
• Mode-independent—Works in any mode.
• Mode-dependent—Works in a specific mode.
To program a mode-independent macro:
1 Press and hold the A and D buttons at the same time until
the LED blinks twice, then release.
2 Enter 9 9 5. The LED blinks twice.
3 Press the button you want to assign to a macro.
4 Enter the series of commands you want the macro to
execute (up to 32 commands).
5 Press and hold SELECT until the red LED blinks twice, then
release.
When you press the preset macro button, the remote sends
the series of commands you have entered, regardless of
what mode you are in. For example, you could program a
macro button to turn on both your TV and cable box and
select a particular channel.
To program a mode-dependent macro:
1 Press the device mode button (DVD, STB, or AUX).
2 Press and hold the A and D buttons at the same time until
the LED blinks twice, then release.
3 Enter 9 7 8. The LED blinks twice.
4 Press the button you want to assign to a macro.
5 Enter the series of commands you want the macro to
execute (up to 32 commands).
6 Press and hold SELECT until the red LED blinks twice, then
release.
When you press the macro button, the remote sends the
series of commands you have entered, but only if you are in
the mode you selected in Step 1. For example, you could
program the macro button to turn on both your TV and
cable box and select a particular channel, but only if you
are in TV mode. If you are in DVD mode, this button does
not execute the macro you set up in TV mode.
Notes
• If more than 10 seconds pass between button
presses, the remote control exits programming.
• If the LED displays one long flash instead,
replace the batteries. If the remote control
continues to display one long flash, the remote
control cannot learn a new button.
Note
Programming a new macro over an existing one
erases the original macro.
Note
To clear the macro, repeat Steps 1 through 5, but do
not enter a series of commands at Step 4.
Note
To clear the macro, repeat Steps 1 through 6, but do
not enter a series of commands at Step 4.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
