Insignia NS-RGFCES2-C User Manual

www.insigniaproducts.com
17
4.8 Cu. Ft. Electric Convection Range with Self Clean and Air Fry
Connecting the power cord
Remove the terminal block cover
1 Remove the screw that secures the terminal block cover to the back of your range. Don’t discard the screws. You need
them to reinstall the cover.
2 For the power cord installation, hook the strain relief over the 1 3/8 in. (3.5 cm) power cord hole located below the rear
of the oven. Insert the power cord through the strain relief, then tighten the relief.
WARNING:
• Electrical ground is required on your range.
• Do not connect to the electrical supply until your range is permanently grounded.
• Your range must be connected to a grounded, metallic, permanent wiring system, or a grounding connector should be connected
to the grounding terminal or wire lead on your range.
Failure to do any of the above could result in a fire, personal injury, or electrical shock.
Note: The power cord connections described below are only applicable to NS-RGFCES2. NS-RGFCES2-C comes with a power cord.
Note: You must install the power cord with a strain relief. Attach the strain relief to the opening in the conduit connection plate.
Terminal block
Strain relief
Power cord
hole
Conduit hole
Power cord
hole

Insignia NS-RGFCES2-C Specifications

General

Brand	Insignia
Model	NS-RGFCES2-C
Category	Convection Oven
Language	English