Insignia NS-RGFCES2-C User Manual

www.insigniaproducts.com
48
Drawer
Steam is coming out of the
vent.
When using the convection
feature, it is normal to see
steam coming out of the
oven vent.
This is normal operation, and not a system failure. Use the
oven as usual.
As the number of racks or
amount of food being
cooked increases, the
amount of visible steam
increases.
A burning or oily odor is
coming from the vent.
This is normal in a new oven
and disappears in time.
Strong odor. An odor coming from the
insulation around the inside
of the oven is normal for the
first few times the oven is
used.
Operate the oven at the bake setting at 400 °F (204° C) for
one hour.
Fan noise. A fan may automatically turn
on and off.
This is normal operation, and not a system failure. Use the
oven as usual.
Oven racks are difficult to
slide.
The shiny, silver-colored racks
were cleaned in a
self-cleaning cycle.
Apply a small amount of vegetable oil to a paper towel and
wipe the edges of the oven racks with the paper towel.
The oven doesn’t self-clean The oven door lock is turned
on.
The display shows the Lock icon. Hold the oven door open,
then press for three seconds. The oven beeps and the
Lock icon turns off.
The oven is too hot. Let the oven cool down, then reset the controls. The
self-clean cycle doesn't lock the oven door if the oven
temperature is too hot. The door must lock before the
self-clean cycle can start.
The self-cleaning oven
controls aren’t set correctly.
Reset the self-cleaning oven controls. See Self-cleaning the
oven page 44.
A surface burner is on. Turn off the surface burner. Self-clean doesn’t operate if a
surface burner is on.
Excessive smoking during a
self-cleaning cycle.
This is the first time the oven
has been cleaned.
This is normal. The oven always smokes more the first time it
is cleaned. Wipe up all excess soil before you start a
self-cleaning cycle. If smoke persists, press OFF/CLEAR.
Open windows to clear the smoke from the room. After the
oven has cooled and unlocked, wipe up excess soil, then
reset the oven self-cleaning cycle.
The oven door does not open
after a self-cleaning cycle.
This is normal. The oven door stays locked until the oven temperature
drops below 400° F (204 °C).
The oven is not clean after a
self-cleaning cycle.
A fine dust or ash is normal. You can wipe the dust or ash clean with a damp cloth.
The cycle was not long
enough to burn off the dirt
buildup.
Extremely dirty ovens require hand-cleaning of excessive
spillovers and food buildup before you start a self-cleaning
cycle. Multiple self-cleaning cycles may be necessary to
completely clean the oven.
PROBLEM POSSIBLE CAUSE SOLUTION
The drawer does not slide
smoothly or drags.
The drawer is out of
alignment
Fully extend the drawer and push it all the way in. See
Removing and replacing the storage drawer
on page 43.
The drawer is over-loaded or
the load is unbalanced.
Reduce weight. Redistribute drawer contents.
PROBLEM POSSIBLE CAUSE SOLUTION

Insignia NS-RGFCES2-C Specifications

General

Brand	Insignia
Model	NS-RGFCES2-C
Category	Convection Oven
Language	English