15
29-Bottle Wine Cooler
www.insigniaproducts.com
Moving your wine cooler
1 Turn off the cooler and unplug it from the wall outlet.
2 Remove all beverages.
3 Securely tape down all loose items inside your cooler.
4 Tape the door shut.
Tips on saving energy
• Locate your cooler in the coolest area of the room, away from heat-producing
appliances or heating ducts, and out of direct sunlight.
• Do not overload the cooler. It forces the compressor to run longer.
• Do not open the door too often, especially if the weather is very hot. Close the
door as soon as possible to prevent cool air from escaping.
• Make sure that the door seals completely to keep your cooler running
efficiently.
• Make sure that the appliance is sufficiently ventilated, with adequate air
circulation behind it.
Troubleshooting
Error codes
If a fault is detected, the display shows one of the following codes:
• E1: Temperature sensor fault
• E4: Defrost sensor fault
If any of these error codes appears on the display, contact your local dealer or
service center. Do not try to repair the cooler yourself.
Note: Make sure that the cooler stays in the upright position during
transportation.
PROBLEM SOLUTION
The cooler does not
operate.
• Make sure that the cooler is plugged in and that
the plug is pushed completely into the outlet.
• Check the house fuse/circuit breaker box and
replace the fuse or reset the circuit breaker.
• If a power failure occurs, the cooler turns off. Wait
until the power is restored, then turn it on again.
The cooler door does not
close completely.
• Adjust the shelf properly.
• Clean the door gaskets.
• Level the cooler with the leveling feet.
The cooler is not cold
enough.
• Make sure that the door is closed properly.
• Allow time for new beverage(s) to cool, then check
again.
• Set the control to a colder setting.
The cooler makes unusual
noises or vibrates.
• Level the cooler with the leveling feet.
• Move the cooler out from the wall.
•This is normal.
To Next Page
Loading...
Need help?
General
