Intel Desktop Board D915GVWB Product Guide
14
Main Memory
NOTE
To be fully compliant with all applicable Intel
®
SDRAM memory specifications, the board should
be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your
memory modules do not support SPD, you will see a notification to this effect on the screen at
power up. The BIOS will attempt to configure the memory controller for normal operation.
The desktop board supports:
• Four 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory Module (DIMMs)
connectors with gold-plated contacts
• Unbuffered, non-registered single or double-sided DIMMs
• Serial Presence Detect (SPD) memory only
• Non-ECC RAM
• 2.5 V memory
• Memory configuration listed below:
⎯ Up to 1.0 GB utilizing 256 Mb technology
⎯ Up to 4.0 GB utilizing 512Mb or 1 GB technology
NOTE
System resources (such as PCI and PCI Express) require physical memory address locations that
reduce available memory addresses above 3 GB. This may result in less than 4 GB of memory
being available to the operating system and applications.
Related Links:
Go to the following links or pages for more information about:
• The latest list of tested memory, http://support.intel.com/support/motherboards/desktop/
• SDRAM specifications, http://www.intel.com/technology/memory/pcsdram/spec/
• Installing memory, page 32 in Chapter 2
Intel
®
915GV Express Chipset
The Intel 915GV Express Chipset consists of the following devices:
• Intel 82915GV Graphics and Memory Controller Hub (GMCH) with Digital Media Interface
• Intel 82801FB I/O Controller Hub (ICH6)
Related Link:
Go to the following link for more information about the Intel 915GV Express Chipset:
http://developer.intel.com/design/nav/pcserver.htm
To Next Page
Loading...
Need help?
General
