Intel Desktop Board DG45ID Technical Product Specification
14
1.2 Legacy Considerations
This board differs from other Intel Desktop Board products, with specific changes
including (but not limited to) the following:
• No parallel port
• No floppy drive connector
• No parallel ATA IDE connector
• No serial port on the back panel
• The serial port header is located near the processor socket and may require a
specialized chassis or cabling solution to use
1.3 Online Support
To find information about… Visit this World Wide Web site:
Intel
®
Desktop Board DG45ID http://www.intel.com/products/motherboard/DG45ID/index.htm
Desktop Board Support http://support.intel.com/support/motherboards/desktop
Available configurations for the Intel
Desktop Board DG45ID
http://www.intel.com/products/motherboard/DG45ID/index.htm
Supported processors http://processormatch.intel.com
Chipset information http://www.intel.com/products/desktop/chipsets/index.htm
BIOS and driver updates http://downloadcenter.intel.com
1.4 Processor
The board is designed to support the following processors:
• Intel Core 2 Quad processor in an LGA775 socket
• Intel Core 2 Duo processor in an LGA775 socket
• Intel Pentium
Dual-Core processor in an LGA775 socket
• Intel Celeron Dual-Core processor in an LGA775 socket
• Intel Celeron processor Sequence 400 in an LGA775 socket
Other processors may be supported in the future. This board is designed to support
processors with a maximum wattage of 95 W. The processors listed above are only
supported when falling within the wattage requirements of the Intel Desktop Board
DG45ID. See the Intel web site listed below for the most up-to-date list of supported
processors.
For information about… Refer to:
Supported processors http://processormatch.intel.com
CAUTION
Use only the processors listed on the web site above. Use of unsupported processors
can damage the board, the processor, and the power supply.
To Next Page
Loading...
Need help?
General
