Intel S2600CO series User Manual

Intel® Server Board S2600CO Family TPS Functional Architecture Overview
Revision 1.4 25
Intel order number G42278-004
Figure 13. Intel
®
Server Board S2600CO DIMM Slot Layout
The following are generic DIMM population requirements that generally apply to the Intel
®
Server Board S2600CO.
 All DIMMs must be DDR3 DIMMs
 Unbuffered DIMMs can be ECC or non-ECC. However, Intel
®
only validates and
supports ECC memory for its server products.
 Mixing of Registered and Unbuffered DIMMs is not allowed per platform.
 Mixing of LRDIMM with any other DIMM type is not allowed per platform.
 Mixing of DDR3 voltages is not validated within a socket or across sockets by Intel
®
. If
1.35V (DDR3L) and 1.50V (DDR3) DIMMs are mixed, the DIMMs will run at 1.50V.
 Mixing of DDR3 operating frequencies is not validated within a socket or across sockets
by Intel
®
. If DIMMs with different frequencies are mixed, all DIMMs will run at the
common lowest frequency.
 Quad rank RDIMMs are supported but not validated by Intel
®
.
 A maximum of 8 logical ranks (ranks seen by the host) per channel is allowed.
 Mixing of ECC and non-ECC DIMMs is not allowed per platform.
 DIMMs with different timing parameters can be installed on different slots within the
same channel, but only timings that support the slowest DIMM will be applied to all. As a

Intel S2600CO series Specifications

General

Brand	Intel
Model	S2600CO series
Category	Server Board
Language	English