28 Intel® Server Board S3420GP User Guide
Figure 5. Intel
®
SAS Entry RAID Module
SAS RAID Support
The BIOS Setup Utility provides drive configuration options on the Advanced | Mass
Storage Controller Configuration setup page for the Intel
®
SAS Entry RAID Module
AXX4SASMOD, some of which affect the ability to configure RAID.
The Intel
®
SAS Entry RAID Module option is enabled by default once the Intel
®
SAS
Entry RAID Module
AXX4SASMOD is present. When enabled, you can set the Configure Intel
®
SAS Entry
RAID Module to either LSI* Integrated RAID or Intel
®
ESRTII mode.
IT/IR RAID Mode
Supports entry hardware RAID 0, RAID 1, and RAID10/10E and native SAS pass
through mode.
When Intel
®
Embedded Server RAID Technology II is enabled with the SAS Module
AXX4SASMOD, enclosure management is provided through the SAS_SGPIO or SES
connector on the SAS Module AXX4SASMOD when a cable is attached between this
connector and the backplane or I2C interface.
Note: For help with navigating the BIOS Setup utility, refer to the Intel
®
Server Board S3420GP
Technical Product Specification.
For information on how to configure RAID, see the RAID software user's guide at:
http://www.intel.com/support/motherboards/server/S3420GP/howto.htm
For information about configure IT/IR RAID, see the IT/IR RAID software user's guide at:
http://www.intel.com/support/motherboards/server/S3420GP/howto.htm
To Next Page
Loading...
Need help?
General
