46 Intel® Server Board S3420GP User Guide
Removing a Processor
1. Observe the safety and ESD precautions in “Safety Information”.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Remove the AC power cord from the server.
4. Remove the server's cover. See the documentation that came with your server
chassis for instructions on removing the server's cover.
5. Unplug the processor fan cable from the server board.
6. Loosen the four captive screws on the corners of the heatsink.
7. Twist the heatsink slightly to break the seal between the heatsink and the processor.
8. Lift the heatsink from the processor. If it does not pull up easily, twist the heatsink
again. Do not force the heatsink from the processor. Doing so could damage the
processor.
9. Lift the processor lever.
10. Raise the CPU load plate.
11. Remove the processor.
12. If installing a replacement processor, see “Installing the Processor”. Otherwise,
install the protective socket cover over the empty processor socket and reinstall the
chassis cover.
Installing a PCI Card
This system does not include peripherals and add-in cards; you must purchase them
separately. The riser card at PCI slot 6 of the board supports a low-profile, half-length PCI
Express* add-in card. Refer to the SR1630GP/SR1630HGP System Service Guide for
more detailed information on how to install a PCI card.
Note: You must attach add-in cards to a riser card when the riser card is removed from the
chassis.
1. Remove the screw that attaches the PCI bracket shield to the rear of the chassis to
remove the shield. Retain the screw.
To Next Page
Loading...
Need help?
General
