Upgrading 27
Removing a Processor
1. Observe the safety and ESD precautions at the beginning of this chapter and the additional
cautions given here.
2. Unplug the heatsink fan.
3. Detach the heatsink clip from the processor socket. See the documentation that shipped with
your processor for more detail.
4. Remove the heatsink from the processor.
5. Raise the locking bar on the socket.
6. Remove the processor from the socket.
7. If you removed the processor from the secondary socket and are not replacing it, you must
install a terminator in its place.
Installing or Removing a Terminator
1. Observe the safety and ESD precautions at the beginning of this chapter and the additional
cautions given here.
2. Raise the locking bar on the socket.
3. Aligning the pins of the processor terminator with the socket, insert the terminator into the
socket.
4. Lower the locking bar completely.
Do these steps in reverse to remove the terminator.
OM10679
Figure 11. Installing a Terminator
To Next Page
Loading...
Need help?
General
