Interlogix NetworX NX-1701E User Manual

Adding One User
ACTION RESULT
& [STAY]
x x x x x x x x
Accesses Activation mode
& [3-digit user number]
Example: X Y [ if 4-digit user code
or
W W X Y [ if 6-digit user codes
x x x x x x x x
If a valid user number is entered, LED1 on any
enabled readers will begin to flash.
Scan the card designated for the user
entered in the previous step.
x x x x x x x x
1) If the user card is not already in the system, it
will be added and mapped to the entered user
number.
2) If the card is already in the system, the reader
will triple beep and LED1 will continue flashing;
the user number is not incremented in this case.
Adding Multiple Users with Auto-Increment
ACTION RESULT
& [CANCEL]
on NX-148E; use [NIGHT] on NX-1248E
x x x x x x x x
Accesses Activation mode
& [3-digit user number]
Example: X Y [ if 4-digit user code
or
W W X Y [ if 6-digit user codes
x x x x x x x x
If a valid user number is entered, LED1 on any
enabled readers will begin to flash.
Scan the card designated for the user
entered in the previous step.
x x x x x x x x
1) If the user card is not already in the system, it
will be added and mapped to the entered user
number and LED1 will continue flashing
indicating that the next user card can be
scanned for the next user number.
2) If the card is already in the system, the reader
will triple beep and LED1 will continue flashing;
the user number is not incremented in this case.
Continue scanning user cards until the
desired number of cards has been added.
x x x x x x x x
After about 30 seconds without a card being
scanned, all the readers in the system will be
updated with the new user card information.
 By default, user cards are added and activated. In order to add a user card and
de-activate it at the same time, scan and hold the card to be added until two
beeps are sounded at the reader.
NX-1701E Installation manual Page 8 31/01/05

Interlogix NetworX NX-1701E Specifications

General

Brand	Interlogix
Model	NetworX NX-1701E
Category	Card Reader
Language	English