2-8
IMPORTANT INFORMATION
If the Engine Has not Been Used for a Long Period
ADVICE
Perform a thorough inspection before starting an engine that has not been run
for a long period of time (one month or longer).
Also, confirm that there is no oil leakage and the oil has been sufficiently
added to the specified level. If the oil level is insufficient, sufficient amounts of
oil may not be getting to all parts of the engine, and could possibly result in a
failure.
With the air intake duct and oil inlet pipe being removed, add the engine oil
to the turbocharger from the oil inlet port. Then, rotate the impeller by hand to
lubricate the bearing adequately. When adding the oil, make sure that foreign
matters such as dust do not enter from the filler port. When oil adding is
finished, securely install the oil pipe and the air intake duct.
Start the engine and idle it at least for 10 minutes. Also, make sure that the
engine produces no abnormal noise.
For warming up operation, refer to "Starting the Engine".
•
•
•
•
Starting the Engine
→ Refer to Page 3-2
IDE-6450A4500781ALL.indd2-8IDE-6450A4500781ALL.indd2-8 2014/04/1814:19:502014/04/1814:19:50
To Next Page
Loading...
Need help?
General
