Isuzu 4LE2 User Manual

5-26
INSPECTION AND MAINTENANCE
Electromagnetic Fuel Pump
Replacing or Cleaning the Filter
The electromagnetic fuel pump may be equipped depending on the machine.
The filter inside the pump is either paper type or steel mesh type. When filter
replacement is required, contact the machine manufacturer. Also, for the replacement
or cleaning periods of each type, refer to the periodic inspection and maintenance list.
Periodic Inspection and Maintenance
List → Refer to Page 5-36
ADVICE
When the filter is removed, make sure to
replace the gasket and clean the magnet
portion inside the cover.
•
1. Disconnect the wiring attached to the pump
cover. Turn the cover using a wrench to
remove it.
WARNING
When removing since the fuel is present inside the pump, use a container or
something similar to receive the fuel, so that the fuel does not splash on the
engine. Also, be cautious of fire.
•
2. Remove the filter and gasket, and replace or
clean them.
ADVICE
Do not disassemble the piston and its
parts locating at the inside center of the
electromagnetic pump.
When removing the gasket, hold the outer
part of the gasket with your fingers and
pull it out.
•
•
Cover
Gasket
Gasket
Electromagnetic pump
Filter
Cover
Gasket
Gasket
Electromagnetic pump
Filter
Disassembly not allowed Disassembly not allowed
IDE-6450A4500781ALL.indd5-26IDE-6450A4500781ALL.indd5-26 2014/04/1814:20:052014/04/1814:20:05

Isuzu 4LE2 Specifications

General

Brand	Isuzu
Model	4LE2
Category	Engine
Language	English