Basic Operation
7. Adjust the output of DC Power Supply 1 from -5V to 5V, and adjust the out-
put of DC Power Supply 2, DC Power Supply 3 from -10V to 10V.
The actual output voltage and current of the instrument will change accord-
ing to the following rules:
• Pin 8 controls the actual output voltage of the instrument from 0V to
500V.
• Pin 9, pin 10 monitor the actual output current of the instrument: When
the output current is higher than the upper limit I+ set by pin 9, the instru-
ment outputs the current at the value of I+; When the output current is
lower than the lower limit I- set by pin 10, the instrument outputs the cur-
rent at the value of I-.
5.13 Restored to Factory Setting (System Reset)
This menu item is used to restore some parameter settings to factory setting
values.
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the System Reset and
press [Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• No: Default value, indicates the instrument cancels this menu setting.
• Yes: Indicates the instrument restores the factory default settings.
4. After the parameter settings are complete, press [Enter].
The parameters affected by System Reset and the parameter values after
reset are shown in the following table.
Table 5–3 Initial value of the parameter
Category Parameter Initial Value
Main
interface
Voltage setting: Vs One percent of the rated
voltage of the
instrument
Current setting: Is One percent of the rated
current of the instrument
Copyright © Itech Electronic Co., Ltd.
189
To Next Page
Loading...
Need help?
General
