EasyManuals Logo
Home>ITech>Power Supply>IT6532D

ITech IT6532D User Manual

ITech IT6532D
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Function and Features
Copyright ©ITECH Electronics Co., Ltd. 20
On( Def )
Turn on static current function (clear
voltage mantissa)
Ext- Ctrl
External control mode and related parameter setting
Voltage( D
ef )
Voltage setting mode selection
10V(Def)/5
V
10V or 5V setting mode selection. select by
left/right key.
Resistance
Resistance setting mode selection. 10K or 5K
setting mode selection, select by left/right
key.
10k/5k
Off
Disable or enable this function. Select by
up/down key.
On
Parallel
Parallel mode set up
Single
Single mode
Master
Act as a master mode
Master Mount: total number of instruments
in parallel.
Slave
Act as a slave mode
Filter
Set the display filter frequency of the power supply
Low
Low speed frequency
Mid( Def)
Middle speed frequency
Fast
High speed frequency
Sense-Protec
t
Enable sense reversed protection function
Disable
Disable sense reversed protection function
Enable( D
ef)
V = 5V: The protect voltage value. Difference
between sense voltage and output voltage.
When exceeds the value, the protection will
be activated.
Delay = 0.1ms( Def ): Protect delay time.
INFO
Product information
Model
Model of power supply
Ver
Software version
SN
Serial number
Last Cal
calibration information for last time
Note
Press
[Shift]+[P-set]( Menu) to view the menu items,press [Esc] to quit menu
operation.Besides,press
[Esc] button can enable you quit the function operation state.
Restored to Factory Setting( >Reset)
This option is used to restore all settings in the system menu to factory setting
values. Press [Enter] to restore to factory setting values. In this case, all set
values in the system will be restored to factory setting values, i.e., the (Def)
mark values.
Configure Power-On State( >Power-on)
When the power-on parameter is set as Rst, at each time of power on, the set
parameters of the power supply will be 0V, 0A and the power rated value. The
parameter setting values under Setup and Function menus will also be restored
to initial values.

Table of Contents

Other manuals for ITech IT6532D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ITech IT6532D and is the answer not in the manual?

ITech IT6532D Specifications

General IconGeneral
BrandITech
ModelIT6532D
CategoryPower Supply
LanguageEnglish

Related product manuals