To Next Page

To Previous Page

Function and Features

Voltage Setting ( Voltage Program)

This function enables change of voltage output through external analog signal

by connecting external DC voltage ( under voltage mode) or an external resistor

( under resistor mode) to Pin 21. To enable this function, the output control

should be under the external analog control mode. Used for controlling the

external voltage range of full-scale output voltage or the resistor can be

selected from 0~5V/0~10V or 0~5KΩ/0~10KΩ. To switch on the voltage setting,

open the MENU ( Menu) → CONFIG ( Configure) → Ext-Ctrl ( External Analog

Control). Press the Right Key to select Voltage ( or Resistance). Press the

Up/Down Key to select the voltage mode or resistor mode.

 Voltage Mode

Under voltage mode, the user can set the voltage output value of power supply

through Pin 21.

 Resistor Mode

Pin 21 and Pin 13 ( GND wire) can be connected to a resistor for setting the

output voltage value of the power supply.

To set the 0~5V/0~10V or 0~5KΩ/0~10KΩ external analog setting range, open

the MENU ( Menu) → CONFIG ( Configure) → Ext-Ctrl ( External Analog

Control). Press the Right Key to select Voltage ( or Resistance).

Press the Right Key to select 5V/10V or 5KΩ/10KΩ within the full scale scope.

Current Setting ( Current Program)

This function enables change of current output through external analog signal

by connecting external DC voltage ( under voltage mode) or an external resistor

( under resistor mode) to Pin 23. To enable this function, the output control

should be under the external analog control mode. Used for controlling the

external voltage range of full-scale output voltage or the resistor can be

selected from 0~5V/0~10V or 0~5KΩ/0~10KΩ. To switch on the current setting,

open the MENU ( Menu) → CONFIG ( Configure) → Ext-Ctrl ( External Analog

Control). Press the Right Key to select Voltage( or Resistance). Press the

Up/Down Key to select the voltage mode or resistor mode.

 Voltage Mode

Under the voltage mode, the user can set the voltage output value of the power

supply through Pin 23.

ITech IT6532D User Manual

Other manuals for ITech IT6532D