ITech IT6800 Series User Manual

Functions and Characteristics
Copyright © Itech Electronic Co., Ltd. 12
Chapter3 Functions and Characteristics
This chapter elaborates on the functions and characteristics of power supplies.
Contents following sections:
 Front-panel operation
 Constant voltage operation
 Constant current operation
 Saving and recalling operation
 Output on/off operation
 MENU operation
3.1 Front-Panel Operation
The power supply is shipped from the factory configured in the front-panel
operation mode. At power-on, the power supply is automatically set to operate
in the front-panel operation mode. When in this mode, the front panel keys can
be used.
When the power supply is in remote operation mode, you cannot use the
front-panel. A change between front-panel and remote operation modes will not
result in any change in the output parameters. You can change the front-panel
and remote operation modes by computer.
The power supply is in Meter mode when it is powered on, and the VFD will
display the actual voltage and current output value. You can operate the
following functions in Meter mode.
 Press [I-set] key, the power supply will changed to Set mode. In Set mode,
the set current value will flash, you can press ▲ and ▼ keys to adjust the
current value.
 Press [V-set] key, the power supply will changed to Set mode. In Set mode,
the set voltage value will flash, you can press ▲ and ▼ keys to adjust the
voltage value.
 In Set mode, the power supply will turn back to Meter mode if there is no
any key is pressed for 3 seconds.
 The output of the power supply can be enabled or disabled from the front
panel by pressing [On/Off] key. When the output is on, the OFF
annunciator will turn off.
 The VFD display shows the present operating status of the power supply
with annunciators. For example, the power supply is operating in CV mode,
and then the CV annunciator will turn on. If, the power supply is remotely
controlled, the Rmt annunciator will also turn on, See ‘‘Display
Annunciators’’.
3.2 Constant Voltage Operation
The constant voltage range is from 0V to the maximum voltage value of each
model. It is very easy for you to set the constant voltage output. You have two
solutions to set the constant voltage value.
 Solution 1:
Step1. Power on the IT6800 series instrument.
Step2. Press the ▲ and ▼ keys to change the value.

ITech IT6800 Series Specifications

General

Brand	ITech
Model	IT6800 Series
Category	Power Supply
Language	English