To Next Page

To Previous Page

Inspection and Installation

1.4 Disassembly of Load Handle

Please disassemble the load handle before installing equipment on the support.

Disassembly steps:

1. Adjust the handle to the position as shown in the figure below.

NOTE

To easily disassemble handle, align the locking mouth and locking device, which is between

the handle and the instrument.

2. Align the locking mouth, and pull out the handle towards two sides.

NOTE

Do not use too much force and mind your hands during disassembly of load handle.

ITech IT8511A+ User Manual

Other manuals for ITech IT8511A+