B
CONTROLS
en-25
Safety, Operation, & Maintenance Manual
Lithium
LCD DISPLAY UNIT (LDU)_____________________________________________
The LDU displays current functional values for the operation of the Eclipse mower, has indicator lights, and sounds audi-
ble warning alerts. The LDU operates in one of two modes, Operator Mode (Default) and Maintenance Mode. Use of
Maintenance Mode requires a four digit pin number.
Press either of the orange buttons (AM or AN) to change screen display or change values. Push the right orange button
(AN) to go forward in the display list or increase setting value, and push the left orange button (AM) to go back in the dis-
play list or decrease setting value. The black button (AL) is used to select, reset or change values.
Fig. 4
Indicator Lights
The LDU has eight indicator lights to indicate system functions.
Power On Light: Green Power On light located on left side of the LDU indicates the controller system has
power. A flashing Power On Light indicates controller systems has not been energized (started). A solid light
indicates the unit is energized and in normal operation mode.
48V Light: Red 48V light located on left side of the LDU indicates system voltage is below 42 VDC or flashes
when system voltage is above 59 VDC. Charge batteries or check generator output. LCD display will show cor-
responding message.
Parking Brake Light: Red parking brake light located on left side of the LDU indicates the parking brake sys-
tem is engaged or brake pedal is fully pressed.
Fault Light: Yellow fault light located on left side of the LDU indicates the controller system has detected a
fault. See fault message displayed on LCD.
!
JACOBSEN
VERSION X.XX
ALAM AN
48 V
12 V
To Next Page
Loading...
Need help?
General
