B
MAINTENANCE
en-63
Safety, Operation, & Maintenance Manual
Lithium
MAINTENANCE
GENERAL __________________________________________________________
• Adjustment and maintenance should always be performed by a qualified technician. If proper adjustments cannot be
made, contact an Authorized Jacobsen Dealer.
• Inspect the equipment on a regular basis, establish a maintenance schedule and keep detailed records.
• Keep the equipment clean.
• Keep all moving parts properly adjusted and lubricated.
• Replace worn or damaged parts before operating the machine.
• Keep all fluids at their proper levels.
• Keep shields in place and all hardware securely fastened.
• Keep tires properly inflated.
• Do not wear jewelry or loose fitting clothing when making adjustments or repairs.
• Use the illustrations in the Parts Catalog as reference for the disassembly and reassembly of components.
• Recycle or dispose of all hazardous materials (batteries, fuel, lubricants, anti-freeze, etc.) according to local, state,
or federal regulations.
FRONT AXLE _______________________________________________________
Remove hex plug and check fluid level. Fluid should be up to the bottom of the plug. Add Mobilfluid 424 or SAE 30 wt. as
required to bring fluid to correct level. Insert plug and clean up any spilled fluid.
To drain fluid:
1. Place a suitable container under front axle.
2. Remove bottom five screws (B), and loosen remaining
screws from differential cover.
3. Being careful not to damage sealing surface, or deform
cover, break seal to drain fluid into pan.
4. Remove differential cover and apply bead of RTV sealant
to axle housing, inside of cover holes.
5. Assemble cover bolts. Torque bolts to 16 - 24 ft. lbs. (21 -
32 Nm).
6. Remove plug (A), and fill with 18 ounces (532 ml) of
Mobilfluid 424 or SAE 30 wt. oil to bring fluid to correct
level. Inert plug and clean up any spilled fluid.
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the
ground, turn system power off, remove key from
ignition switch, and disconnect battery pack(s) to
prevent injuries.
Make sure the mower is parked on a solid and level
surface. Never work on a mower that is supported
only by the jack. Always use jack stands.
!
Fluid Level
at bottom
of plug.
A
B
B
To Next Page
Loading...
Need help?
General
