B
en-84
Safety, Operation, & Maintenance Manual
ADJUSTMENTS
Lithium
HOOD STOPS _______________________________________________________
1. Adjust position of hood stop bumpers (Z) as required so
hood contacts bumpers with approximately 1/8 in. (0.3
cm) clearance between hood and cowlings.
2. Adjust left and right side bumpers as required so hood is
level.
3. Test operation of hood latch. Hood latch must be able to
latch hood.
4.
LIFT STOPS ________________________________________________________
If the lift actuators make a ratcheting sound when being raised, lift stop adjustment may be required. Lift stops must be
adjusted with lift system in Mow Mode. See Lift System on page 43.
1. Loosen left and right reel stop hardware (AA).
2. Start mower, turn mow switch on, and fully raise reels.
Shut off mower.
3. Adjust left reel stop bracket (AB) so reel stop pin (AC) is
resting in bracket slot. Tighten hardware (AA). If addi-
tional adjustment is needed, adjust position of stop pin
(AC).
4. Repeat for right reel stop bracket.
5. Loosen hardware (AD). Adjust left reel bumper and
bracket (AE) to contact left reel in fully raised position.
6. Repeat bumper adjustment for right reel bumper.
7. Loosen hardware (AF). Adjust left side bumper (AG) to contact center reel in fully raised position. Hardware (AF) is
located on battery tray on battery power modules and buffer battery tray on hybrid power modules.
8. Loosen hardware (AJ). Adjust right side center reel bumper (AH) to contact center reel. Adjust center bumper (AK)
if required.
To Next Page
Loading...
Need help?
General
