36
NOTES
- Activating the blower and the hydromassage pumps at the
same time may turn the heater off, if it is on.
- When the blower is star ted, the filtering pump is also turned
on, if it was not already. It will remain on for 1 0 minutes after
the function is turned off.
I UNDERWATER SPOTLIGHT
This spotlight is turned on using the key located on control panel:
Press the “Light” key to turn on the spotlight located on
the wall of the tub.
NOTE: some models have a white light led spotlight.
The spotlight stays on for 2 hours. It can be shut off before
that by pressing the key again.
The colour combinations are regulated in terms of tones and
intensity by the built-in digital system.
Cromodream
This cycle allows you to experience the entire colour range - co-
lours appear in complimentary fashion, merging from one colour
to the next, providing complete satisfaction.
Sunlight
A colour trio (yellow/orange/white), with short interspersions
of sky blue and violet, reminiscent of the beneficial effects of so-
lar light; yellow alternated with violet uplifts mood and improves
general physical balance.
Relax
Formed of the following colours: blue/orange/sky blue/white,
this sequence relieves stress and encourages relaxation; the o-
range hue offers warmth in this sequence composed primarily
of "cold" colours.
Steady colours
You can also choose from the following colours, which appear
in stable fashion: white, light blue, orange, yellow, green.
NOTE: when you turn on the spotlight, the filtering pump is al-
so turned on, as there is probably someone in the tub. It stays
on for 10 minutes after the spotlight is turned off.
Utility functions
I CONTR OL PANE L LOCK
There are two modes for this function:
- Partial lock: this makes it impossible to programme the filtering
cycle or change the water heating set point. You also cannot acti-
vate the energy savings mode (Econo) or rapid filtering (“Instant
Clear”).
All other control panel keys remain active.
- Total lock: this mode prevents operation.
Partial lock
To activate this function:
Press and hold the “Econo” key for a few seconds. The
symbol for the locked panel will flash on the display ( ). Con-
tinue holding the key until the message “LocP” appears and the
symbol stays on steady, which indicates that the lock has been
activated.
If you press a key whose use is not permitted, the display will
show the message “LocP" for five seconds.
Total lock
To activate this function:
Press and hold the “Econo” key. The symb ol for the
locked panel will flash on the display ( ). Continue holding
the key even after the message “LocP” appears, until the mes-
sage “LocF” appears. The function is now active.
If you press any key, the display will show the message
“LocF" for 5 seconds.
De-activating the lock
In b oth modes, to de-activate the lock, press and hold the “E-
cono” key until the message “LocP” or “LocF” disap-
pears and is replaced by the message “U Loc”.
NOTES
- If their is a power outage, the keyboard lock (either par tial
or total) is removed.
- If y ou want to change from par tial lock to total lock (or vice-
versa), you must first deactivate the current lock and then set
the new lock mode.
I TEM P ORARY SYSTE M S HUTDOWN
(“STAN DBY”)
This function lets you suspend operation of all system devices for
a period of 60 minutes (this value cannot be changed) so that
you can perform routine maintenance without having to discon-
nect the power supply.
To Next Page
Loading...
Need help?
General