Jacuzzi J-200 Series Owner's Manual

J-200
11.1 Programming the Primary Filtration
During the primary ltration cycle, the pump 1 low speed and
CLEARRAY are activated. The hot tub is programmed to cycle 4 times
(every 6 hours) throughout the day, each cycle last 2 hours, and a default
start time of 12:00 AM, but this can be changed.
A. Primary Filtration Menu
To change the programmed Primary Filtration Cycle:
Note: If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.
1. Press until you get to the “PF” Menu. The display will scroll
“PRIMARY FILTER.” After the second scroll, if no action is taken, the
system will revert back to the Main Menu.
2. Press or to display the current start time and prepare the
system for changes.
3. Press or to adjust the start time, in 1-hour increments. To
switch from “AM” to “PM” you must round a 12-hour period.
4. Press
1
to conrm and save the start time.
5. Press or to adjust the number of cycles per day, either 1, 2,
3, 4 or 8 cycles in a 24-hour period.
6. Press
1
to conrm and save the changes.
7. Press or to adjust the duration of the cycles, either 1, 2, or 3
hour cycles.
8. Press
1
to conrm and save the duration time. The system will
return to the “PRIMARY FILTER” Menu.
In extreme bitter cold weather, where freezing can occur, we
recommend you program the primary ltration cycle to run
for a minimum of 8 hours per day. Refer to the “Winterizing”
section on page 39.
11.2 Programming the Heating Mode
Your hot tub is equipped with 3 modes of heating. An automatic mode
called “AUTO,” where the hot tub’s temperature is maintained at all
times. An energy saving heating cycle called “ECO.” Lastly, a mode that
will only activate the heater during the daytime called “DAY” mode.
• Economy Mode is an energy savings program. The hot tub is allowed
to heat between 5:00 PM and 7:00 AM every day. The hours are not
programmable.
• Day Mode allows the hot tub to heat during the day, between 7:00
AM to 5:00 PM. The hours are not programmable.
• Auto Mode allows the heater to heat, at all times, in order to maintain
the preset temperature.
Note: The heater will reactivate after the water cools to
approximately 2°F (1°C) below the set temperature.
31

Jacuzzi J-200 Series Specifications

General

Brand	Jacuzzi
Model	J-200 Series
Category	Hot Tub
Language	English