J-200
A. Programming the Heating Mode
To change the programmed heating mode:
Note: If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.
1. Press until you get to the “HEAT” Menu. The display will scroll
“HEATER MODE.” After the second scroll, if no action is taken, the
system will revert back to the Main Menu.
2. Press or to prepare the system for changes. Continually
press to scroll through the following modes:
• Economy Mode: The screen will display “ECO” and scroll
“ECONOMY MODE.”
• Day Mode: The screen will display “DAY” and scroll “DAY MODE.”
• Auto Mode: The screen will display “AUTO” and scroll “AUTO
MODE.”
3. Once a selection is made, press
1
to conrm and activate the
setting. The system will return to the “HEATER MODE” Menu.
11.3 Programming the Change Filter Timer
A programmable lter timer can be set to remind you when to clean or
replace the lters.
• The default setting is for 180 days.
• The timer range is from OFF to 180 days, in increments of 10 days.
Note: It is not recommended that this feature be turned OFF. In order to
continually maintain clean and working lters, it should be program as
instructed.
A. Programming or resetting the timer.
Note: If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the
current settings will remain active.
1. Press until you get to the “FC” Menu. The display will scroll
“FILTER CHANGE.” After the second scroll, if no action is taken, the
system will revert back to the Main Menu.
2. Press or to prepare the system for changes. Continually
press to adjust the length of time for the timer.
3. Once you select the number of days, press
1
to conrm this
selection. The system will return to the “FILTER CHANGE” Menu.
4. Once the timer expires, the display will alternate between the water
temperature and “CHANGE FILTER”, page 49.
32
To Next Page
Loading...
Need help?
General
