J-200
14.6 Panel Displays Change Filter
The lter change timer has expired. The spa lters need to be cleaned
or replaced. The display will alternate between the current temperature
reading and the scrolling message “CHANGE FILTER” as long as the
error exists. The countdown timer for the Change Filter feature needs to
be reset (page 32). New lters can be purchased from a local Jacuzzi
dealer.
14.7 Panel Displays Change Water
The water refresh timer has expired. The spa needs to be drained and
relled. The display will alternate between the current temperature
reading and the scrolling message “CHANGE WATER” as long as the
error exists. The countdown timer for the Change Water feature needs to
be reset (page 33).
14.8 Panel Displays FL--1
An “FL--1” display means the ow switch is malfunctioning
open, the lter cartridge is excessively dirty or an “air lock”
condition has occurred at the Jets Pump 1 intake. The spa heater will
deactivate and jets pump #1 may also deactivate. Contact your
authorized Jacuzzi dealer or qualified service technician. The display will
alternate between “FL--1,” scrolling message “FLOW ERROR OPEN”
and the current water temperature.
14.9 Panel Displays FL--2
An “FL--2” display means the ow switch is malfunctioning
closed. The spa heater will deactivate and jets pump #1 may
also deactivate. Contact your authorized Jacuzzi dealer or qualified
service technician. The display will alternate between “FL--2,” scrolling
message “FLOW ERROR CLOSED” and the current water temperature.
14.10 Panel Displays FL--3
An “FL--3” display means the ow switch is behaving
erractically. The spa heater will deactivate and jets pump #1
may also deactivate. The display will alternate between “FL--3,” scrolling
message “FLOW ERROR TOGGLE” and the current water temperature.
Make sure to clean the lter(s) and correct proper water level before
contacting your dealer or service organization.
49
To Next Page
Loading...
Need help?
General
