Page 41
J-400
10.0 Registration and Start-up
10.1 Start-up Sequence
During the start-up sequence, the welcome screens will appear, Figure
10.1a. Then a blow out cycle will begin, page 54. After the cycle ends,
the hot tub will either display the Registration Menu or the Home Menu.
Note: The start up menu will time out after approximately 3 seconds.
10.2 Register Your New Spa
Registering your spa is important in order to
validate your warranty. In order to register you
will need to have the spa serial number, Figure
10.2b, then you will need to register online in
order to receive a passcode (not applicable to
export models). A passcode is only given for
North American models only. The passcode
must be entered on the control panel in order
to unlock the Registration Lockout screen, Figure 10.2c.
If this option is skipped, you will be able to activate components, but,
after 10 minutes, the screen will revert back to the registration screen.
This process will continue until the spa is registered and the passcode
(North American models only) is entered.
Note: The spa will still protect itself if an error is detected.
To register your spa you need to have
your spa serial number. The best time to
retrieve the serial number is when the
spa is being connected. You must
register your spa via the internet at
www.Jacuzzi.com.
Follow these steps to register your spa.
1. Using your home computer or other device, connect to
the internet.
2. Go to www.Jacuzzi.com website to register your spa.
3. Click Outdoor Hot Tubs
4. Click For Owners
Figure 10.1a
WELCOME
Spa 1.14 / Panel 2.01
WELCOME
Reminder
Please register your spa at:
www.Jacuzzi.com
Once registered, enter your
spa serial # and registration
passcode here:
laterenter #
Figure 10.2a
Figure 10.2b
serial
nameplate
Power
on
Lamp
on
DANGER!
TURN POWER
OFF! DO NOT
LOOK AT LIT BULB.
SEVERE EYE
DAMAGE OR BLINDNESS
CAN OCCUR!
To Next Page
Loading...
Need help?
General
