EasyManuals Logo
Home>Jacuzzi>Hot Tub>J-470

Jacuzzi J-470 User Manual

Jacuzzi J-470
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Page 66
J-400
B. To drain your spa, perform the following
steps (QuickDrain):
Note: To avoid any injuries, more than one indi-
vidual must perform these steps.
1. Turn off power to hot tub at the breaker.
2. Locate the doors retractable push button on the top
of the front panel, Figure 13.2e.
3. Press the retractable push button to release the
panel door from the spa frame, Figure 13.2f.
4. Slowly and gently tilt the panel forward and then lift
up to remove, Figure 13.2g. This will expose the
equipment bay for easy access to the components.
Place the panel in a safe location to prevent
from damaging it.
5. Locate the QuickDrain valve, Figure 13.2h.
6. Unscrew drain valve cap, Figure 13.2i. Place
the cap aside.
7. Screw in the adapter with hose that was
included in the equipment bay; attach it to the
QuickDrain, Figure 13.2j. Make sure to direct
the hose to an area where the water will drain
properly.
8. Open the drain slice valve by sliding the handle
to the side and pulling up.
Note: If the QuickDrain is slow, remove the circulation
pump lter to ease the ow.
9. After the hot tub has drained close the slice valve by
pushing it downward and sliding the handle to the
side. Remove the adapter and reinstall the QuickDrain
cap before relling hot tub.
10. To reinstall the panel just follow the steps above in
reverse order.
After relling, turn on power to the spa and follow the steps
listed under “Spa Fill Up Procedures” (page 18). Always ll
your spa through both lter buckets.
13.3 Cleaning the Spa Interior
To preserve the sheen of your spa’s surface, it is crucial
that you avoid using abrasive cleaners or cleaners which have adverse
chemical effect on the surface. If you are not certain as to the suitability
of a particular cleanser, consult your authorized Jacuzzi dealer. We
recommend using Jacuzzi’s Spa All Purpose Cleaner to clean the spa’s
interior surface. Use extreme care to assure that no soap residue is left
on the surface. This could cause severe sudsing when the spa is relled.
Jacuzzi chemicals are for use in the U.S. only.
Figure 13.2e
Figure 13.2f
Figure 13.2h
Figure 13.2j
Power
on
Lamp
on
DANGER!
TURN POWER
OFF! DO NOT
LOOK AT LIT BULB.
SEVERE EYE
DAMAGE OR BLINDNESS
CAN OCCUR!
Figure 13.2i
Power
on
Lamp
on
DANGER!
TURN POWER
OFF! DO NOT
LOOK AT LIT BULB.
SEVERE EYE
DAMAGE OR BLINDNESS
CAN OCCUR!
Figure 13.2g

Table of Contents

Other manuals for Jacuzzi J-470

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi J-470 and is the answer not in the manual?

Jacuzzi J-470 Specifications

General IconGeneral
BrandJacuzzi
ModelJ-470
CategoryHot Tub
LanguageEnglish

Related product manuals