4
3.0 Main Control Panel Functions
3.1 J-LX Control Panel
A. 2013+ P/N 6600-506 SMT panel (replaced 6600-239 early in 2013)
B. 2011-2012 P/N 6600-440
1
2
H
A
D
B
C
E
G
F
Display shown for example purposes only, actual water tem-
perature display will vary.
Button Function
A
LED Display: Can display current water temperature (default display), water temperature setpoint, selected
ltration/heating mode, and error messages.
B
Warmer Button: Increases water temperature setpoint.
C
Cooler Button: Decreases water temperature setpoint.
D
Light Button: Turns waterfall, footwell and accent lighting on in unison. Press once for high intensity, a sec-
ond time for medium intensity, a third time for low intensity, a fourth time to turn off. The displayed color is
changed using the light mode button (E) below.
E
Light Mode Button: Selects one of 4 color modes for waterfall, footwell and accent lighting.
F
Jets 1 Button: Turns jets pump #1 on and off. Press once for low speed; a second time for high speed and a
third time to turn off.
G
Jets 2 Button: Turns high-speed jets pump #2 on and off. Press once to turn on; a second time to turn off.
H
Heat Indicator: Lit when heater is on.
OPERATION DETAILS
• Temperature Adjustment: 65 to 104°F (18 to 40°C); temperature override not possible. Software default setting is
100°F (38°C).
• Light System Operation: Light runs for 2 hours then shuts off.
• Jets Button Operation: Jets run for 20 minutes after activated then turn off automatically to conserve energy.
Simply press JETS Button to continue operation for an additional 20 minutes.
To Next Page
Loading...
Need help?
General