(II)
5，10，30，60：Auto off with less than 9d of gross weight when there is not any operation
within 5min (10, 30, 60min available)
4)
SET03
using units setting: Kg Kg，Kg g，g g，lb lb
Note: it refers to the weighing unit and unit weight unit.
Such as, if Kg, G is selected, it means the weighing unit is Kg and unit weight unit g.
5)
SET04
zero range setting: d0, d1, d2, d3, d4, d5.
d0: display zero with 1 d placed on the pan.
d1: display zero with 2 d placed on the pan. No display with 1d on the pan.
So do as d2, d3, d4 and d5
6)
SET05
weight checking setting: on, off
On: weight checking starts automatically when powering on
Off: weight checking closes when powering on
7)
SET06
stable weight checking setting: on, off
On: it starts checking weight when the weight and amounts are within the checking range
and the stable symbol appears.
Off: it starts checking weight when the weight and amounts are within the checking range
8)
SET07
beep setting: Hi，ok ，Lo，out，no.beep
Hi: There will be a warning sound when the material quantity is more than the upper limit,
and the weight of the material is more than 20 divisions
Ok: There will be a warning sound when the quantity of the articles is between the upper
and lower limit (including the upper and lower limits).
Lo:
There will be a warning sound when the material quantity is less than the lower limit,
and the weight of the material is more than 20 divisions.
Out: There will be a warning sound when the material quantity exceeds the upper and
lower limits, and the weight of the material is more than 20 divisions
no.beep: No sound alarm.
9)
SET08
external equipment setting: PC 、JMS、Godex 、BIRCH、ZEBRA、
DMP、CK 、ET 、CX
PC: computer output
JMS: connect with weighing system
To Next Page
Loading...
Need help?
General
