Jandy Pro Series User Manual

To disable the power display feature, from the service
setup menu select
DISPLAY POWER USAGE. Press
MENU to select. Using the arrow keys, select NO. Press
MENU to accept and store.
Section 5. User Set Up Options
NOTE The controller must be in the OFF mode before
entering the user setup mode. While in setup
mode the controller will return back to the OFF
mode after one (1) minute since the last key
press.
When in setup mode, speed keys "

" through "4" are
used as ‘escape’ or exit keys while navigating the setup
menu.
To enter the setup mode, press and hold the
MENU
button for ve (5) seconds. The controller displays
SELECT USER SETUP. Using the arrow keys, select
the desired setup item to change.
5.1 Setting Time-of-Day
From the Setup menu, select SET TIME. Press the
MENU button to display the currently-set time. Using
the arrow keys, adjust to the desired time. Press
MENU
to save your setting.
5.2 Labeling Speeds
The controller comes from the factory with pre-
programmed labels or names for the preset speeds. The
labels may be changed as desired to suit your particular
installation.
Two (2) types of labels are provided by the controller:
• General Labels - selected from a list
• Custom Labels - created by the user
From the setup menu, scroll to LABEL SPEED
and press MENU. The SELECT SPEED screen
is displayed. Press the
MENU button to display the
currently selected speed. Using the arrow keys, choose
the speed to be changed. Press
MENU to select. The
controller displays
SELECT LABEL TYPE. Select
GENERAL or CUSTOM as desired using the arrow keys.
SELECT USER SETUP
LABEL SPEED
5.3 General Labels
Using the arrow keys, select a general label from the list
to assign to the speed. Press
MENU to assign the label to
the speed.
LABEL SPEED
FILTRATION
5.4 Custom Labels
In the custom label mode, the controller displays a
ashing cursor at the character position to be changed.
Using the arrow keys, change the character as desired.
Press
MENU to accept the change and advance to the
next character position. Press any speed key "

"
through "4" to return to the previous cursor position.
LABEL SPEED
1:PRESET 1
Continue this procedure until the end of the label is
reached. The new label is saved when
MENU is pressed
at the last character position.
5.5 Display Light Control
The controller’s display is equipped with a backlight to
aid viewing in low light conditions.
PAGE 16
JEP-R Variable-Speed Pump Controller
|
Installation Manual
ENGLISH

Jandy Pro Series Specifications

General

Brand	Jandy
Model	Pro Series
Category	Controller
Language	English