RS T4F Diesel Generator
|
G220RS 19
Battery isolator
The battery isolator switch is used to disconnect the
battery from the machine electrics. The switch must
be turned to the off position if any maintenance
work is to be performed on the machine.
Some machine systems perform shut down cycles
after the engine stops. Wait until shut down cycles
are complete before setting the battery isolator
switch to the off position.
At the end of a working cycle or if the machine is
being left unattended and the lights are not required,
the battery must be isolated.
The control system is designed such that if the
battery isolator is switched off then there is a 2min
time delay to de-energise the ECU (Electronic
Control Unit) to allow the DEF (Diesel Exhaust
Fluid) purge to complete its shutdown cycle.
Disconnect the Machine Electrics
1. Get access to the battery isolator.
2 Turn the battery isolator key in a
counter-clockwise direction and remove.
Connect the Machine Electrics:
1. Insert the battery isolator key and turn in a
clockwise direction.
Fig 10
A Battery isolator key
To Next Page
Loading...
Need help?
General
