19
JCB-MS-254SB-L
Instruction & User Manual
Important. To make 90° crosscuts, the
extension block (16a) must be fixed at the inner
position.
• Open the set screw (16b) for the adjustable
stop rail and push the adjustable stop rail
inwards.
• The extension block (16a) must be fixed far
enough in front of the innermost position
that the distance between the extension
block (16a) and the saw blade (6) amounts to
a maximum of 0.3” (8 mm).
• Before making a cut, check that the
extension block (16a) and the saw blade (6)
cannot collide.
• Secure the set screw (16b) again.
• Loosen locking handle (11) and lift up the
release lever (28).
• Use locking handle (11) to adjust the turn
table (14) to the desired angle. The bevel
pointer (12) on the turn table must match
the desired angle on the scale (13) on the
fixed saw table (15).
• Re-tighten the locking handle (11) in order to
secure the turn table (14).
• Cut as described under section “Cross cut
90° and turn table 0°”.
Precision adjustment of the stop
formitre cut 45° (Fig. 1/9/10)
• Lower the machine head (4) and secure
using the fastening bolt (23).
• Fix the turn table (14) in the 0° position.
• Loosen the locking screw(22) and use the
handle(1) to angle the machine head (4) 45°
to the left.
• 45° - position angle stop between the saw
blade (6) and turn table (14).
Cross cut 90° and turn table 0° - 45°
(Fig. 8)
The crosscut saw can be used to make
crosscuts of 0° -45° to the left and 0° -45° to
the right in relation to the stop rail.
Fig.8
Fig.9
4
11
16a
16b
1312
23
38
6
14
Fig.10
To Next Page
Loading...
Need help?
General
