24
JCB-MS-254SB-L
Instruction & User Manual
Important information
In the event of an overloading, the motor will
switch itself off. After a cool-down period (time
varies) the motor can be switched back on
again.
Damaged electrical connection cable
The insulation on electrical connection cables is
often damaged.
This may have been caused by the following
issues:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been
improperly fastened or routed.
• Places where the connection cables have
been cut due to being driven over.
• Insulation damage due to being ripped out of
the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables
must not be used and are life-threatening due
to the insulation damage.
Check the electrical connection cables
for damage regularly. Make sure that the
connection cable does not hang on the power
network during the inspection.
Electrical connection cables must comply
with the applicable VDE and DIN provisions.
Only use connection cables with the marking
“H07RN-F”.
The printing of the type designation on the
connection cable is mandatory.
AC motor
• The mains voltage must be 120 V~ 60Hz
• Extension cables up to 82ft (25 m) long
must have a cross-section of 1/162” (1.5
mm2) .
2
Connections and repairs of electrical
equipment may only be carried out by a
qualified electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
Transport
• Tighten the locking handle (11) in order to
lock the turn table (14)
• Press the machine head (4) downwards and
secure with the fastening bolt (23). The saw
is now locked in its bottom position.
• Fix the saw’s drag function with the locking
screw for drag guide (20) in rear position.
• Carry the equipment by the fixed saw table
(15).
• When reassembling the equipment proceed
as described under “Before starting the
equipment”
To Next Page
Loading...
Need help?
General
